Tree removal can be very dangerous and also life-threatening It really is never recommended to remove a tree all on your own unless this can be a small one that you're confident it is possible to handle safely Otherwise, tree removal ought to be left in the hands of professionally-trained and equipped tree service contractors Should you have a tree on your own property that is fairly small, but should be removed, you can possible do it yourself with the proper tools, knowledge, and planning Tree Removal Preparation Proper preparation for small tree removal involves gathering all your needed supplies, as well as, a comprehensive inspection of the tree Turn to see if the tree leans one way or the other, and plan an escape route in case it generally does not fall how you expect it to fall Also, examine whether you can find any obstacles in virtually any direction of the tree, including vehicles, structures, and other trees When you are sure there is enough safe clearance for the tree to fall, then you can certainly move ahead to gathering your equipment and tools This includes Safety Gear Utility gloves, goggles, hard hat, steel toe boots, etc Chainsaw Ax or Hacksaw Ladder Rope Wedges First Aid Kit To Remove a Tree Once you have all your equipment and supplies, you can get started removing the tree First, use your ax to knock on the bark a few times, and in several different places, to learn how solid or hollow the tree is Getting a less dense area to cut will be easier Next, plan which side of the tree you need to make your cut Turn to see where the tree naturally leans; it is best to cut a tree in the direction in which it wants to naturally fall Be sure the area where the tree drops is level therefore the tree does not roll or bounce after it falls Make a horizontal cut at hip-height, and about 1/3rd into the tree Do this on the side of the tree where you want it to fall If you would like the tree to fall to the proper, you must cause you to cut on a single side so that it falls inward, towards the cut The tree will fall perpendicular to your horizontal cut Your next cut should develop a wedge into the tree So make https//northlondontreesurgeoncouk/ at an angle from the original cut It should look like a lemon wedge Your third cut is called a back cut, and is ought to be made on the contrary side of your wedge cut This cut will make the tree fall over privately of your wedge cut Make it about 15 inches above the wedge cut, so when thick as possible Also you can use a wedge to avoid the tree from settling onto the chainsaw Add more wedges as necessary until the tree begins to fall Then run But usually do not turn your back on the tree since it falls